# Cleaning Cupping Bowls and Cups

How to clean cupping bowls, glass cupping cups and the rest of a cupping set between tastings, so residue from one sample does not carry into the next.

Cleaning cupping bowls and cups is a short, repeated job: remove coffee residue with warm water and a soft cloth, rinse well, and dry before the next sample goes in. The routine covers cupping bowls and cups, glass tasting cups and the spoons that travel between them. It also explains how to clean a full cupping set when the session ends and how to keep one sample from tainting the next during cleaning between tastings. 

## Water and cloth do the work 

Warm water and a soft cloth remove coffee residue from cupping bowls and cups without scratching the surface. Fill the bowl, rub the inside with the cloth, and pour the water out rather than letting it stand. Glass cupping cups show residue clearly, so hold them to the light after rinsing and wipe any film away. Skip abrasive pads and scented detergent, because both leave marks a taster can smell or taste. 

## Rinse between samples and spoons 

Rinsing between samples keeps flavors separate, and the cupping spoons deserve the same care as the bowls. Keep a jug of clean warm water beside the table and rinse each spoon before it enters a new cup. Wipe the spoon dry on a clean cloth so water does not dilute the next sample. Change the rinse water when it darkens, and never put a used spoon back into the shared water without a wipe. 

## Deep clean the whole cupping set 

A full wash of the cupping set belongs at the end of a session, not between samples that follow each other closely. Wash bowls, cups and spoons in warm water with a small amount of unscented dish soap, then rinse until the water runs clear. Dry everything upside down on a clean towel so water does not pool in the base. Store the set uncovered and dry, since a closed container traps moisture and odor. 

## Questions about cleaning cupping vessels 

### How do I clean glass cupping cups without clouding them? 

Glass cupping cups clean safely with warm water and a soft cloth, and they stay clear when you avoid abrasive pads. Hold the glass up to the light after rinsing, because a thin coffee film hides on clear walls. Dry the cup with a lint-free cloth so water spots do not dry onto the surface. Hot water alone loosens residue, and a mild unscented soap helps when oil clings. 

### What should I use to clean coffee cupping bowls? 

Warm water with a soft cloth cleans coffee cupping bowls, and a small amount of unscented dish soap handles oily residue. Rinse the bowl until the water runs clear, since soap left behind alters the aroma of the next sample. Avoid scented detergents, because their perfume lingers in porous surfaces and reaches the nose during tasting. Dry the bowl fully before it holds coffee again. 

### How do I clean a cupping set after a session? 

A cupping set gets a full wash with warm water and mild unscented soap once the session ends. Wash the bowls, cups and spoons together, rinse each piece well, and dry them upside down on a clean towel. Store the set dry and open to air, because trapped moisture brings odor. Check the spoons for coffee oil along the bowl before the set goes away. 

### How do I keep flavors separate when cleaning between tastings? 

Cleaning between tastings works best with a rinse of warm water and a wipe, plus a second rinse for strong samples. Keep one jug of clean water for the vessels and a separate one for the cupping spoons. Replace the water when it looks dark, because a dirty rinse carries flavor from one sample into the next. A dry cloth on hand removes water before the following cup is filled.
