# How to Change Grind Size on Commercial Espresso Grinders: Mazzer and Mahlkonig

Adjust espresso grind on Mazzer and Mahlkonig commercial grinders: find the dial or collar, move it in small steps, purge, and recalibrate for a new coffee.

Changing grind size on a Mazzer or Mahlkonig commercial espresso grinder means moving the adjustment collar or dial in small, deliberate steps and then checking the result with a shot. Mazzer grinders turn a stepped or stepless collar below the hopper, while Mahlkonig models use a numbered dial or a stepless knob depending on the model. On both, the burrs stay where they are and the distance between them changes, so the coffee comes out finer or coarser. The goal is a repeatable grind size calibration that responds to the coffee you have in the hopper. 

## Find the adjustment on each grinder 

Locate the adjustment point before you touch anything, because the two brands place it differently. On a Mazzer commercial burr grinder, the collar sits at the top of the grinding chamber and turns to raise or lower the upper burr. Mahlkonig machines often use a numbered grinder setting dial on the front or a stepless adjustment knob, depending on the model. Read the maker's manual for your specific machine, since the direction and the locking method vary. 

## Move the grind in small steps 

Turn the espresso grind dial in small increments and note the direction you moved it. A fine grind runs the shot slower, while a coarse grind speeds the flow, and the change should be a nudge rather than a swing. Mark the starting position with tape or a pencil line so you can return to it. On a stepped Mazzer collar, each notch is a fixed step, and on a stepless model you judge the move by feel and by the shot. 

## Purge and check the new setting 

Grind and discard a small dose after any adjustment, because the first coffee out holds grounds from the old setting. Pull a shot with the new grind and watch the flow, then adjust again if it runs too fast or too slow. Keep the dose and the brew ratio steady, so only the grind changes between shots. Repeat the small move, the purge and the taste check until the coffee sits where you want it. 

## Questions about Mazzer and Mahlkonig grind settings 

### How do you change grind size on a Mahlkonig grinder? 

Mahlkonig grinders change size through a numbered setting dial or a stepless knob, found on the front or side of the machine depending on the model. Turn the dial toward finer or coarser in small steps, then purge a little coffee and pull a shot to judge the result. Record the number so you can return to that Mahlkonig grinder setting later. 

### How do you change grind size on a Mazzer grinder? 

Mazzer grind adjustment works through the collar at the top of the grinding chamber, which raises or lowers the upper burr. Turn the collar a small amount in the direction the manual shows, purge the first grind, and check the shot. A Mazzer collar that is stepped clicks into notches, while a stepless collar moves freely. 

### Which way should you turn the dial to make espresso finer? 

Turn the espresso grind dial toward the finer side, which brings the burrs closer together and slows the shot. The direction on the collar or dial depends on the grinder model, so confirm it in the manual before you move it. Make one small move, purge, and test before going finer again. 

### Why does the grind setting drift after cleaning or a new coffee? 

Grind size calibration shifts after cleaning, burr removal or a change of coffee, because the burrs reseat and the new beans behave differently. Return the dial to your recorded mark and expect a small correction to bring the shot back. Keep a written log of the setting for each coffee so the drift stays easy to trace.
