# How to Use a Burr Grinder Step by Step

A plain walkthrough of using a burr grinder: setting the grind adjustment, filling the hopper, dosing beans, purging retained grounds and checking burr alignment.

Learning how to use a burr grinder step by step means working in a fixed order: set the grind adjustment, fill the hopper, dose your beans, grind, and purge what stays behind. Each step exists for a reason, and skipping one shows up in the cup as an uneven extraction. The order below keeps the process repeatable, so a change you make can be traced to one variable. The steps suit any manual or electric burr grinder, and the details that differ between models are named where they matter. 

## Set the grind before you dose 

A burr grinder should be adjusted while the burrs are running or empty, because beans trapped between the burrs resist the change. Turn the grind adjustment toward the finer end for espresso-style brewing and toward the coarser end for filter methods. Record the setting you used, since a dial marked with numbers rarely matches another grinder. Change one step at a time and taste before you move again. 

## Fill the hopper and dose by weight 

The hopper holds beans, and its shape feeds them into the burrs at a steady rate while it has weight above the throat. Weigh the dose on a scale rather than filling a scoop, because bean size and roast level change how much a scoop holds. A hopper run low can feed beans unevenly, so keep enough beans above the burrs for the dose you plan. Single-dosing grinders skip the hopper question and take one weighed portion at a time. 

## Purge what the grinder retains 

Purging retained grounds means running a small amount of fresh coffee through the burrs and discarding it before you grind your dose. Grounds left in the chute and around the burr chamber are stale and land in the next portion. The amount retained depends on the model and how much ground coffee sits inside it. Grind a little, throw it away, then grind the dose you weighed. 

## Burr grinder questions answered 

### How do I know if my burrs are aligned? 

Burr alignment means the two burr faces sit parallel, so the gap between them stays even around the circle. A grinder that will not produce a consistent grind at any setting, or that screeches at the finest setting, may have misaligned burrs. Checking and correcting alignment takes patience and the right tools, and a trained technician should do it on a grinder you cannot take apart safely. 

### Should I adjust the grind while the grinder is running? 

Yes, adjust the grind adjustment while the burrs turn or while the chamber is empty. Turning the dial against a full chamber of beans can jam the burrs or damage the adjustment mechanism. Run the motor, move the dial in small steps, then grind a little coffee to check the result. 

### Why do I need to purge retained grounds? 

Purging retained grounds removes stale coffee that stayed inside the grinder after the last dose. Those old grounds mix into your fresh dose and add a flat, woody taste to the cup. A short purge before each brew keeps the flavor of the new beans clear. 

### Does the hopper affect how evenly the grinder feeds beans? 

The hopper feeds beans into the burrs by gravity, and a steady column of beans above the throat gives an even feed. A nearly empty hopper can let beans bounce and enter the burrs unevenly, which changes the grind. Keep the hopper filled enough for the dose you are grinding.
