THE PERSONAL BREW BENCH

How to Use a Percolator to Make Coffee

Assemble a percolator, add water and coffee grounds, set the heat and stop the brew at the right moment. A short guide to each percolator step.

4 min read1 views
— · 0 votes
Contents
  1. Fill and assemble the pot
  2. Set the heat and watch percolation
  3. Brewing for one person
  4. Percolator coffee questions
  5. How do you use a percolator for the first time?
  6. What kind of coffee grounds go in a percolator?
  7. How long should percolator coffee brew?
  8. Can you make coffee for one person in a percolator?

To use a percolator to make coffee, fill the pot with water, seat the basket of coffee grounds on its stem, put the pot on the heat and let the percolation cycle run until the coffee is as strong as you want it. The pot lifts boiling water up the stem and sprinkles it over the grounds, then the liquid falls back through for another pass. Because the same liquid passes the grounds again and again, the brew gets stronger with every cycle, so the stopping point is your main control. The steps below cover single-cup brewing, the finished pot and the questions a first timer asks.

Fill and assemble the pot

Percolator brewing starts with cold water in the pot and coffee grounds in the metal basket that sits on top of the stem. Use a coarse grind, close to what a French press takes, because fine particles slip through the basket holes and end up in the cup. Seat the stem in its base, set the basket on the stem and check that the lid fits without touching the grounds. Do not fill the pot past its marked level, since space must be left above the water for the coffee to spread without boiling over.

Set the heat and watch percolation

A stovetop percolator works by pressure from boiling water, so the heat must be high enough to start percolation and then turned down to keep it gentle. Watch through the glass knob at the end of the stem and count or time the cycles once the coffee starts to bubble up. A gentle pump over the grounds gives an even extraction, while a violent boil pushes water through too fast and brings fine grit into the liquid. Start with hot water from a kettle if you want the percolation cycle to begin sooner.

Brewing for one person

A coffee percolator for one person works the same way as a full pot, only the water and the grounds are measured to a smaller batch. A single cup percolator may be a small stovetop unit with its own basket, and it still needs enough water to cover the heating element or base. Measure a ratio of coffee grounds to water and keep that ratio steady, then record the brew time so you can repeat the cup. When the grounds in the basket are exhausted, the liquid keeps circulating and turns bitter, so a small batch is better than a weak one made too long.

Percolator coffee questions

How do you use a percolator for the first time?

A first percolator brew needs a clean pot, cold water below the fill line and coarse coffee grounds in the basket. Place the basket on the stem, close the lid and set the pot on the heat until you hear the first bubbling. Turn the heat down then, let it percolate gently and remove the pot from the heat when the coffee reaches the taste you want.

What kind of coffee grounds go in a percolator?

Coarse coffee grounds suit a percolator best, since fine grounds pass through the basket holes and settle in the cup. The grounds need room to swell, so fill the basket loosely and leave it slightly short of the rim. A little less coffee is easier to control than a basket packed tight, because the percolation liquid must be able to move through the bed.

How long should percolator coffee brew?

Brew time in a percolator depends on the grind, the amount of coffee and how much water is in the pot, so gauge it by taste rather than a fixed rule. After the pot begins to bubble, turn down the heat and let a few gentle percolation cycles pass. Take the pot off the heat and taste the coffee, since every further cycle adds strength and bitterness.

Can you make coffee for one person in a percolator?

A percolator can brew a single cup if you scale both water and grounds to the size of the pot. Small stovetop percolators hold enough for one serving and reach their cycle sooner than a large pot. Keep the ratio of grounds to water the same as a larger batch, then stop the brew as soon as the flavor is right.

Read next

Latest articles