# Putting a Filter in a Brita Pitcher

Learn how to put a filter in a Brita pitcher: soak and prime the cartridge, set it in the reservoir, seat the lid, and get clean-tasting water for brewing.

Putting a filter in a Brita pitcher means soaking a new cartridge, priming it under running water, and seating it firmly in the upper reservoir so water passes through it before reaching the lower chamber. The task takes a few minutes and needs only the pitcher, a fresh cartridge, and a tap. Doing the steps in order keeps carbon fines out of your brewed water and helps the filter sit without leaks around its seal. 

## Soaking and priming the new cartridge 

Soaking the filter in cold tap water loosens the carbon dust left from manufacturing. Let the cartridge sit in a bowl of water for a short while, then rinse it under a running tap to flush the loose particles. Priming means letting water run through the cartridge so the carbon bed is wet before the pitcher is filled. A wet filter lets water pass at an even rate from the first use. 

## Seating the filter in the reservoir 

The filter cartridge sits in a shaped slot inside the upper reservoir of the Brita pitcher. Push the cartridge down until it clicks or seats fully against the rubber gasket at the base of the slot. A cartridge that sits at an angle lets unfiltered water slip past its seal and into the lower chamber. Check that the slot is free of grit or old carbon before you press the new cartridge home. 

## Filling and fitting the lid 

Fill the reservoir with cold tap water and let it drain through the cartridge into the lower chamber. The lid locks the cartridge in place and keeps dust and debris out of the water while it filters. Press the lid down evenly so both sides catch, then run one batch of water through and discard it. That first batch carries the loosest carbon dust, so pour it away before you drink or brew. 

## Questions about fitting a Brita filter 

### How do you put a filter in a Brita pitcher? 

Putting a filter in a Brita pitcher starts with soaking and rinsing the new cartridge under a tap. Press the cartridge into the slot in the upper reservoir until it seats against the gasket, then fit the lid and fill the reservoir with cold water. Let the first batch drain through and discard it before you use the pitcher. 

### Do you have to soak a Brita filter before use? 

Yes, a new Brita filter needs soaking and rinsing before its first use. Soaking in cold water loosens the carbon dust left from manufacturing, and rinsing under a tap flushes it away. Skipping this step can carry dark particles into the lower chamber and into your water. 

### Why does water leak around the filter in the pitcher? 

Water leaks around a Brita filter when the cartridge does not sit flush against the rubber gasket in its slot. Lift the cartridge out, check the slot for grit or a dislodged gasket, and press the cartridge down again until it seats. A lid that is not fully clicked into place can also let the cartridge shift. 

### What is priming a water filter cartridge? 

Priming a water filter cartridge means running water through it so the carbon bed is fully wet before regular use. A primed cartridge passes water at an even rate and filters from the first fill. Soaking and rinsing a new cartridge primes it before it goes into the Brita pitcher.
