THE PERSONAL BREW BENCH

Document espresso spraying and uneven flow before changing preparation

Build a repeatable espresso observation record that separates what you saw, like spraying or uneven flow, from what you suspect caused it and what you change next.

5 min readBrew journal10 viewsDocument espresso spraying and uneven flow before changing preparation
— · 0 votes
Contents
  1. The short answer
  2. Why separate the symptom from the suspected cause
  3. What to record for every shot
  4. A plain-text template you can copy
  5. Choose one preparation change to test
  6. Run a controlled comparison
  7. How to read the result
  8. Keeping the record useful over time

The short answer

Before you change your grind, dose, distribution or tamp in response to a spraying or lopsided espresso shot, write down what you actually observed in one place and your guess about the cause in another. Then change one preparation variable at a time and repeat the comparison. This keeps a visible symptom, such as a spurt from one side of the basket, from being recorded as a proven diagnosis, and it lets you tell later whether a change helped or whether something else changed at the same time.

This guide covers a home brewing record: what to capture for each shot, how to set up a fair comparison, and how to read the result without overstating it. It does not rank equipment or explain every possible cause of uneven flow.

Why separate the symptom from the suspected cause

Spraying and uneven streams are easy to see, so it is tempting to label them immediately. The usual label is channeling. Hugh Inc., in its guidance for the Leverpresso, describes channeling as water taking preferential routes through the coffee. That definition is about what happens inside the puck, which you cannot see directly. The stream leaving the basket is a clue, not proof of a particular internal cause.

If your notes say "channeling" instead of "spray from the left edge starting partway through the shot," you lose the information you would need to check that explanation later. Keeping two columns, one for observations and one for hypotheses, preserves both.

What to record for every shot

Use the same fields every time so shots can be compared line by line. Fill in what you know and leave a field blank rather than guessing.

FieldWhat to writeColumn
BrewerMachine or manual lever you usedSetup
GrinderGrinder nameSetup
Portafilter and basketWhich portafilter and which basket, so you can tell if either changedSetup
CoffeeBean, roaster, roast date if knownSetup
Actual doseWhat you weighed, not what you intendedSetup
Grind settingThe setting as marked on your grinderSetup
Preparation sequenceEach step in order, e.g. grind, distribute, level, tampSetup
Target and actual yieldWhat you aimed for and what you gotSetup
Named timing eventsMoments you define and reuse, such as pump start, first drops, end of shotObservation
Symptom locationWhere the spray or uneven flow appearedObservation
Symptom onset and durationWhen it started relative to a named event and how long it lastedObservation
Photo or video referenceFile name or note, if you took oneObservation
TasteYour own tasting noteObservation
Suspected explanationYour current guess, clearly marked as a guessHypothesis
Evidence neededWhat comparison would support or rule out that guessHypothesis

Named timing events are your own convention. Pick a few moments you can identify consistently, give them letters, and use the same letters on every shot. Then an observation can read "spray began near event C" instead of a vague "near the end."

A plain-text template you can copy

SHOT ID: ____        DATE: ____

SETUP
  Brewer: ____
  Grinder: ____          Grind setting: ____
  Portafilter/basket: ____
  Coffee: ____
  Dose (actual): ____
  Yield (target / actual): ____ / ____
  Prep sequence: ____

TIMING EVENTS (my convention)
  A = ____   B = ____   C = ____

OBSERVATION (what I saw, heard, tasted)
  Location: ____
  Onset: ____            Duration: ____
  Photo/video: ____
  Taste: ____

HYPOTHESIS (what I suspect, not proven)
  Suspected explanation: ____
  Evidence needed to evaluate it: ____

Example of a correctly split entry, for illustration only: in the observation section, "spray began near event C, left edge of basket"; in the hypothesis section, "suspected channeling; check by comparing a more even distribution with the same dose, basket and yield target."

Choose one preparation change to test

Base your first change on guidance that applies to your equipment. For Leverpresso users, Hugh Inc. recommends spreading the grounds evenly before tamping and keeping the tamp level. Those two steps are natural candidates for a comparison, but test them separately so you know which one mattered. If you use a different brewer, check its manufacturer's instructions for preparation steps before choosing what to vary.

Run a controlled comparison

  • Record a baseline shot (A) using your current routine, filling in every field.
  • Pull a comparison shot (B) that differs in only the one preparation step you chose.
  • Repeat the comparison so a single unusual shot does not decide the result.
  • Keep the coffee, basket, dose, yield target and timing convention the same across all of them.
  • Write the observations first, then update the hypothesis column.

If more than one condition changed between A and B, such as a new bag of beans or a different basket, keep the notes but do not credit the result to any single change.

How to read the result

Illustrative example: the spray disappears in shot B, but you also switched baskets and adjusted the grind. The honest entry is "symptom absent in B; cause unresolved." Your next step is to plan another comparison that changes only one of those three things.

A cleaner-looking stream tells you the visible symptom changed. It does not by itself show that extraction inside the puck became even. Let your taste notes and repeated shots carry weight alongside the appearance of the flow, and keep the hypothesis column open until the comparisons support a conclusion.

Keeping the record useful over time

  • Give each shot an ID so photos, videos and notes can be matched later.
  • Never overwrite an old hypothesis; add a new dated line so you can see how your thinking changed.
  • When you change equipment, start a new baseline instead of comparing against shots from the old setup.
  • Note anything that changed outside your control, such as a fresh bag of the same coffee, in the setup fields.

Related articles