Record a Nel Drip Recipe, Pouring Sequence and Beverage Yield
Build a cloth-filter brewing journal that keeps the author's nel drip method intact, logs each pour and pause as it happens, and records beverage yield as its own measurement.
Contents
To record a nel drip brew, write down three separate things: the recipe version you chose, what you actually poured and when, and the weight of coffee you collected at the end. Keeping them apart lets you repeat a cloth-filter brew faithfully and see where a cup changed. The most common mistake is treating total water added as the beverage yield. They are different numbers, because the grounds and the cloth filter hold some of the water you pour.
What a nel drip journal is for
Nel drip is a pour-over method that uses a cloth (flannel) filter. Published recipes differ in dose, water temperature and pour-and-pause timing, so a journal serves two purposes. It preserves one author's method exactly as written, and it captures your real brew next to it. Tim Bunting, who writes about using nel drip at home, stresses repeating a chosen ratio for consistency and tasting with attention to aroma, initial flavor and aftertaste. A journal makes both of those habits practical.
Start with the recipe version
Begin each entry by naming the brewer, the filter and the specific recipe you are following. If you try a second author's method, give it its own version label. Do not merge two authors' pauses and quantities into one schedule, because a combined schedule belongs to neither author and gives you nothing reliable to compare against.
Example version record, using the nel drip guide from Davila Kafe:
- Coffee dose: 50–55 g, coarsely ground
- Water temperature: near 175°F
- First pour: 45 g over 45 seconds, then a 45-second pause
- Second pour: 80 g over 60 seconds, then a 20-second pause
- Third pour: 60 g over 30 seconds
- Author-stated total brew time: 3½ minutes
- Final beverage weight: not specified by the author
Davila Kafe also describes how it prepares the cloth filter. Treat steps like that as part of that author's method, not as a general rule for every cloth filter. Attach them to the version they came from, then record separately whether you followed them.
Check the arithmetic before you brew
Add up the schedule before you use it. In the Davila Kafe example, the water additions total 45 + 80 + 60 = 185 g. The listed pour and pause intervals total 45 + 45 + 60 + 20 + 30 = 200 seconds. The guide gives the total as 3½ minutes, which is 210 seconds.
Do not change either figure to make them agree. Put 200 seconds in a 'schedule total' field and 210 seconds in an 'author-stated total' field. Then use a timer during the brew to record the actual elapsed time. Your timed brews will show which figure better matches what happens in your setup.
Log one row per pour or pause
The pouring table is the core of the journal. Give each water addition and each pause its own row, and record the target and the actual value side by side. A running cumulative-water column catches small overpours that would otherwise go unnoticed.
| Phase | Target addition | Actual addition | Cumulative water | Planned duration | Actual start / end | Pause | Pour location or pattern (as instructed) | Deviation |
| Pour 1 | 45 g | 45 s | ||||||
| Pause 1 | — | — | 45 s | yes | — | |||
| Pour 2 | 80 g | 60 s | ||||||
| Pause 2 | — | — | 20 s | yes | — | |||
| Pour 3 | 60 g | 30 s |
Leave the actual columns blank until you brew. The deviation column is for anything that differed from the plan, such as a pour that ran long, a pause cut short, or a pattern you could not follow.
Record drip events as they happen
Two moments matter in addition to your pours: the first drip and the end of collection. Some authors build their timing around the first drip. Tim Bunting, for example, describes pouring slowly at the start, then waiting roughly 20 seconds after the first drip before the main pour. If you brew from a schedule like that, write down when the first drip appeared and how long you actually waited. Without those times, you cannot tell whether the recipe was followed.
Measure beverage yield on its own
Weigh the collected coffee after brewing and record it as the beverage yield. Do not fill this field with the total water added. In the example above, 185 g is the water you poured, not the coffee in your cup. If you did not weigh the result, leave the field empty rather than estimate it. A missing value is more useful than a wrong one when you compare brews later.
A complete journal entry template
RECIPE VERSION
Author / source name:
Version label:
Brewer:
Filter:
Author's preparation steps (attached):
Preparation actually followed:
INPUTS
Coffee dose (g):
Grind setting:
Water temperature:
SCHEDULE CHECK
Total water from additions (g):
Schedule total from listed intervals (s):
Author-stated total time:
POURING LOG
[one row per pour or pause - see table]
EVENTS
First drip (elapsed time):
Final collection ended (elapsed time):
Actual total elapsed time:
OUTPUT
Beverage yield (g, weighed):
TASTING
Aroma:
Initial flavor:
Aftertaste:
Notes for next brew:
Use your entries to repeat or adjust
Once you have several entries for the same recipe version, compare them. Look at actual against target pours, measured elapsed time, beverage yield and your tasting notes. If a cup you liked came from a brew that drifted from the written schedule, save that brew as a new personal version. Keep the original author's version unchanged. This leaves you with a faithful record of the published method and a separate record of the routine that works best for you.
Related articles
Record a Bruer cold-drip brew from setup to beverage yield
A practical log for a Bruer cold-drip session: method check, Bruer's setup quantities, drip-rate counting, timing events, collected beverage and cleanup notes.
Organize Existing Coffee Equipment Around Your Brewing Workflow
Set up a DIY home coffee station using only what you own: map your brewing sequence, group tools by use, check placement, and record a repeatable routine.
Keep a personal tasting record as one coffee brew cools
A practical guide to recording successive tasting notes from a single coffee brew as it cools, using elapsed time, measured temperatures and clear comparisons.
Identify and record your espresso machine's preinfusion phase
How to find your espresso machine's documented preinfusion phase, copy its controls and units, and log observed phase events in a brew journal tied to each shot.
Interpret and record espresso pressure readings in context
Looking for the optimal bar pressure for espresso? Learn what your gauge actually measures, how to tell a setting from a reading, and how to log pressure so your numbers can be compared.
Record espresso basket dimensions, dose ratings and headspace
58mm espresso baskets share a diameter but differ in depth and dose range. How to record basket specs, actual doses and headspace checks without guessing at fit.
Record espresso pressure and flow profiles as separate observations
Build a stage-by-stage espresso profile record that keeps intended settings, measured pressure, measured flow and inferred curve segments apart.
Build a model-specific percolator brewing journal
Record your percolator's model, instructions, heat source, brewing events and completion cues so you can repeat a stovetop or electric routine and compare recipes fairly.
Document espresso spraying and uneven flow before changing preparation
Build a repeatable espresso observation record that separates what you saw, like spraying or uneven flow, from what you suspect caused it and what you change next.
Compare espresso adjustments with a controlled shot journal
Use a controlled shot journal to test espresso adjustments one variable at a time, alongside taste guides like the Barista Hustle Espresso Compass.